Use a Ac To USB Female Adapter Conmmonly Avaliable In The Market And Connect The USb Cable to that and connect the usb cable to the programmer ,If everything is Well the PWR red light will glow ". The Do Not Connect This To your Desktop or Laptop. If You find any Issues Rectify Them With Desoldering wire / Pump. Double Check it for Any Dry soldering, Short Soldering ,Wrong component Installed At Wrong Place ,Polarity Based Components Installed the Other Way Around. Once This is Done Only the ISP Header, The 40 Pin ZIFF Socket And The 2 Pin Male Header Is Left To Be soldered Into This PCB. Its Always Fine To Have All The Components Fitted tightly to the PCB. I Would Recommend Someone To Solder Pin No 1 and 21 Or 40 And 20 So That it Remains in The PCb And All Other Pending Legs Can Be Soldered Without The Base Moving. Kindly Make sure The Cut in The IC Base And the SilkScreen Match.
Now Its The Time To install The 40 Pin IC Base Where You Will Install The " Micro-controller that is Programmed With Enhanced Willar SP200S Code ". You will See Sometimes that the Capacitors actually have a higher voltage then rated in The "BOM " Bill of material ,this is Fine. Please Remember the Electrolytic Capacitors Have Polarity And the Negative Lead Is Shorter Then the positive Lead And On The PCb the Negative side Is Having White Lines. After This Install The electrolytic Capacitors. Once this Is Done Install The Inductor "this will have no polarity ".You Can Use any 9014 Or 8050 Transistors.For This To Happen Once you are assembling make sure you press the transistor in the pcb as much as you can. Other Then The Q1 and q4 All Transistors Are Under The MCU 40 Pin IC Base And Hence After Assemble Make sure you Press Them From One side and Tilt them To 90 Degree. This Kit Comes With Two 8550 Transistors and 4 Transistors.Remember the Crystal is Installed Without any Polarity issues. The 22.1184 Drives The MCU And The 12 Mhz Drives the USB To Serial Converter chip. These Do Not Have Polarity Unlike The LEDS. Once This Is done Please Install The Two Crystals.The Shorter leg is the -Ve and Should Be Installed Towards Your Tummy / Where willar SP200S Is Written. Kindly Note That One Leg of This Component Is Longer and That is the anode +Ve side And should be Installed Facing Towards The Main MCU Chip. Make Sure The Red Goes Into The PWR Area And The Green Into the STA Area on the pcb. Once This is Done Leave The Other Capacitors for the Time Being. Once This is Done Pick Those 104 Coded Capacitors and Install Then they Are 0.1 Micro Farad. The Code On This Would Be 221 And on the first 22pf would be 22 Only. Then Install the Single 220 pf Capacitor.
Let Me Guide you With the Actual Installation Here. Once The small components are done ,Please proceed with the installation of Larger components Like The Smaller Capacitors ,Larger Electrolytic Capacitors, Inductor, LED ,Resistance Bridge ,Crystal And the Main Connector for USB.
0 kommentar(er)
